Hook-up diagnostic scanner test equipment to perform OBD II communications test. Retrieve trouble fault codes #PO300, 301,302,303,304,305,306. Perform live data checks of systems voltages and sensor operations. Perform visual inspection of all emission related components. All sensors operating in correct ranges at this time. Recommend to adjust all valves before any further diagnostics can be performed and quote estimate of repairs to customer.
Richard N. gave our service a 5 star review on 3/12/2026
Changed engine oil & replaced oil filter. Replaced with up to 5 qts synthetic oil, lubricate chassis where required, re-set maintenance monitors, perform complete vehicle light check, and check all fluid levels and tire pressures.
Anna U. gave our service a 5 star review on 11/23/2025
Change oil and oil filter. Install up to 5 qts of synthetic blend oil, check all fluid levels, re-set maintenance monitors, perform complete vehicle light check, and set tire pressures to correct settings.
Registration renewal
Aleta C. gave our service a 5 star review on 10/23/2025
Remove and replace cabin air filter, and clean all debris from ducts area.
Check battery life of all tire pressure sensors with TPMS tool. Retrieve sensor id #'s and load them into tire scanner. Connect to OBD connector, and up-load new ID'S to vehicle PCM. Test drive to re-set system.
Josh M. gave our service a 5 star review on 10/17/2025
Remove, dis-mount, and mount customer supplied new tires, and computer balance. (Reverse mount rims)
Check battery life of all tire pressure sensors with TPMS tool. Retrieve sensor id #'s and load them into tire scanner. Connect to OBD connector, and up-load new ID'S to vehicle PCM. Test drive to re-set system.
Oleg G. gave our service a 5 star review on 12/23/2024
COIL SPRING – Remove & Replace – Rear, Both Sides [Includes: Bleed Brake System (where applicable). DOES NOT include alignment.]
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [Includes: R&I Stabilizer Bar.] – [DOES NOT include disassemble or alignment.]
Computer balance (4) tires (included)
Remove tires from vehicle, dismount and mount (4) customers supplied tires, and computer balance.
Changed engine oil & replaced oil filter. Replaced with up to 6.6 qts synthetic oil, lubricate chassis where required, and check all fluid levels and tire pressures.
Remove and replace rear brake pads. Retract rear brake caliper pistons, clean and lubricate all guides, and adjust when required.
Check front suspension and steering components. Compensate wheel sensors, set caster, camber, and toe-in to manufactures specifications with all factory adjustment areas.
Install axle support and lower splash pan adapter bushings
Install new front link kits
Chuck R. gave our service a 5 star review on 4/5/2024